Line-X Protective Coatings - High Performance Coatings

Please allow Active-X Control to play the video

Untitled Document

Unlike other spray-on or drop-in bedliners, a LINE-X^® treatment is professionally applied at high pressure and high temperatures, bonding instantly and permanently to your truck.

Made from a two-part polyurethane elastomer system, LINE-X uses equal parts of an "A" component, or hardener, and a "B" component, or resin. Using special equipment, the two liquids are combined right outside the tip of the spray gun. When the two parts are combined properly, the result is a polyurethane elastomer with tough, durable, protective properties.

The LINE-X dries in just 3 to 5 seconds, preventing runs or pooling that can occur with a cold, low pressure spray-on product.

With a pre-scheduled appointment, the total job (including bed preparation, masking and spraying) takes about two hours and your truck is ready immediately, but wait a day before you put it to the test.

Watch the video to see our LINE-X spraying process in action.

Instruction for allowing Active-X Control

1. Look for the Internet Explorer Information Bar (see Figure 1) near the top of your Web browser.

Figure 1: Internet Explorer Information Bar

2. Right-click the Information Bar and click Install ActiveX Control in the menu (see Figure 2).

Figure 2: Internet Explorer Information Bar menu

Note If the Install ActiveX Control command is not displayed in the Information Bar menu, you will need to use the Alternate Validation Method described below.

3. In the Security Warning dialog box, click Install.